Select Source

Contents ShowHide

The Select Source screen is used to select an imaging device if more than one imaging device is connected to the computer.

Select Source screen

Screen Access

With two or more imaging devices attached to your computer and powered on, complete either of the following:

Display the Participant Folder screen for a client > On the Document Imaging menu, select Scan a Document.

Interface Initialization

Upon initial display of the screen, the following occurs:

The title bar text is set to "Select Source".

The Source list box is enabled and populated with all detectable imaging devices.

The OK button is visible and enabled as the default.

The Cancel button is visible and enabled as the default.

Screen Elements

Unless otherwise stated below, all controls on the Select Source screen are visible and enabled when:

The screen is displayed in Add mode.

If one or more special conditions exist that affect a control on the Select Source screen, the condition(s) are documented for that specific control below.

Source list box

View items in the Source list box.

The Source list box contains all imaging devices that are connected to the computer and can be detected by the system. Select the imaging device that the system should use for scanning a document.

OK button

Click the OK button to process the screen.

It is the default button for the screen, unless otherwise noted.

It does not have a mnemonic. Its keyboard shortcut is the Enter key.

When the OK button is clicked, the following actions occur:

If a selection was made in the Source list box, the Scan Document screen displays.

If a selection was not made in the Source list box, a standard error message (E0301) displays.

Cancel button

Click the Cancel button to close the screen without processing or saving data.

It does not have a mnemonic. Its keyboard shortcut is the Esc (escape) key.

The calling screen displays when the button is clicked.

Processing

If data can be validated and saved on the screen, the following processes occur when the screen is processed:

A process to check for required controls as identified in the Data Map below is performed.
A process to check for valid entries as identified individually for each applicable control in Screen Elements above is performed.
A process to check for edits and cross edits as identified for each applicable control in Screen Elements above is performed.
If any checks or processes fail, a standard error message displays.

If no data can be validated and saved on the screen:

No cross edits are performed.
All values are considered legitimate.
No data is written to the database.

Data Map

The Data Map defines the values saved for all controls on the screen. If available, any additional notes or comments are displayed in the Notes column.

Control Label	Control Type	Table. Column	Notes
~Source	list box	·	Displays a list item for each imaging device that is connected to the computer and can be detected by the system.

~ Denotes a required control (if applicable). The process that checks for required controls does not occur on screens displayed in read-only or Details mode.

+ Denotes data written to the database when screen processing occurs (if applicable). The process that writes data to the database does not occur on screens displayed in read-only or Details mode.

Software Version: 2.40.00